Windmaster Roof Ventilation, Roof Ventilation, Roof Ventilation Systems, Industrial Ventilation, Industrial Ventilation Systems, Evaporative Coolers, Axial Fans, Roof Turbine Ventilation

Aqua-breeze Evaporative Coolers

Industrial Roof Ventilation

Domestic Ventilation System

Axial Fans

Vortec Furnace Ventilators

Product Overview Videos

Distributor Application

Industrial Ventilation

Domestic Ventilation

Chimney Champ Ventilation

Evaporative Coolers

Furnace Ventilators

TURBINE INSTALLATION PROCEDURES


Place the baseplate onto the roof and mark the hole to be cut. ensure that the baseplate is pushed under the ridge cap.	Cut the marked hole square with an angle grinder	Bend the sheeting back at the bottom end of the cut out and remove closure from under ridging


Insert closure at the bottom end of baseplate and pop rivet the baseplate onto the roof	Waterproof baseplate using silicon or membrane and sealer	Place the throat and dome section onto the baseplate


Make sure that the locking brackets are loose	Adjust throat in order to get the top section of the throat and the dome in a level position	Fasten the locking brackets


Fix the throat onto the baseplate by drilling and using pop rivets	If more than one unit is required stagger the units across the roof

+27 11 452 8256

Copyright © Windmaster
EngNet Designed by EngNet Design Group

Windmaster Roof Ventilation, Roof Ventilation, Roof Ventilation Systems, Industrial Ventilation,
Industrial Ventilation Systems, Evaporative Coolers, Axial Fans, Roof Turbine Ventilation, Whirly Vent